ຄູ່ມືຜູ້ໃຊ້ Dolphin S50 Robotic Pool Cleaner

ແນະນຳ

The Dolphin S50 Robotic Pool Cleaner is an advanced, lightweight, and compact solution designed for efficient cleaning of small pools up to 8 meters in length, including above-ground pools. It features smart navigation, active brushing, and single-level filtration to ensure a clean and healthy swimming environment. This manual provides essential information for the safe and effective operation and maintenance of your Dolphin S50.

Figure 1: Dolphin S50 Robotic Pool Cleaner, front view showing the blue PVC brushes and tracks.

ຂໍ້ມູນຄວາມປອດໄພ

Please read all safety instructions carefully before operating the Dolphin S50. Failure to follow these instructions may result in damage to the product, property, or personal injury.

• ສະເຫມີຕັດການເຊື່ອມຕໍ່ການສະຫນອງພະລັງງານກ່ອນທີ່ຈະດໍາເນີນການບໍາລຸງຮັກສາຫຼືທໍາຄວາມສະອາດ.
• Do not operate the cleaner if the power cable is damaged. Contact authorized service for repair.
• ໃຫ້ແນ່ໃຈວ່າໜ່ວຍສະໜອງພະລັງງານຖືກວາງໄວ້ຢ່າງໜ້ອຍ 3.5 ແມັດ (11.5 ຟຸດ) ຈາກຂອບສະລອຍນ້ຳ.
• ຢ່າລົງໄປໃນສະລອຍນໍ້າໃນຂະນະທີ່ເຄື່ອງເຮັດຄວາມສະອາດກໍາລັງເຮັດວຽກ.
• ໃຊ້ສະເພາະໜ່ວຍສະໜອງພະລັງງານຕົ້ນສະບັບທີ່ມາພ້ອມກັບເຄື່ອງເຮັດຄວາມສະອາດເທົ່ານັ້ນ.
• ຮັກສາໜ່ວຍສະໜອງພະລັງງານໃຫ້ຫ່າງຈາກນ້ຳ ແລະ ແສງແດດໂດຍກົງ.
• ເຄື່ອງໃຊ້ນີ້ບໍ່ໄດ້ມີຈຸດປະສົງເພື່ອໃຊ້ໂດຍບຸກຄົນ (ລວມທັງເດັກນ້ອຍ) ທີ່ມີຄວາມສາມາດທາງຮ່າງກາຍ, ຄວາມຮູ້ສຶກ ຫຼືຈິດໃຈທີ່ຫຼຸດລົງ, ຫຼືຂາດປະສົບການ ແລະຄວາມຮູ້, ເວັ້ນເສຍແຕ່ວ່າພວກເຂົາໄດ້ຮັບການຊີ້ນໍາ ຫຼືຄໍາແນະນໍາກ່ຽວກັບການນໍາໃຊ້ເຄື່ອງໃຊ້ໂດຍບຸກຄົນທີ່ຮັບຜິດຊອບຄວາມປອດໄພຂອງເຂົາເຈົ້າ.

ເນື້ອໃນຊຸດ

ກວດ​ສອບ​ວ່າ​ລາຍ​ການ​ທັງ​ຫມົດ​ແມ່ນ​ມີ​ຢູ່​ໃນ​ຊຸດ​:

• Dolphin S50 Robotic Pool Cleaner Unit
• ຫນ່ວຍບໍລິການສະຫນອງພະລັງງານ
• Fine Filter Basket (pre-installed)
• ຄູ່ມືຜູ້ໃຊ້ (ເອກະສານນີ້)

Note: Caddy and caddy cover are not included and must be purchased separately.

Figure 2: Dolphin S50 shown with optional caddy and cover, which are sold separately.

ຕັ້ງຄ່າ

1. Positioning the Power Supply Unit

   Place the power supply unit at least 3.5 meters (11.5 feet) from the edge of the pool. Ensure it is in a shaded area and not exposed to direct sunlight or standing water.

2. Connecting the Cleaner to the Power Supply

   Connect the floating cable from the cleaner to the power supply unit. Ensure the connector is fully inserted and secured.

3. ການວາງເຄື່ອງເຮັດຄວາມສະອາດໃນສະນຸກເກີ

   Gently lower the Dolphin S50 into the pool. Allow it to sink to the bottom, releasing any trapped air bubbles. Ensure the floating cable is untangled and spread out on the water surface to prevent tangling during operation.

   

   Figure 3: Gently lowering the Dolphin S50 into the pool.

4. Connecting the Power Supply to the Mains

   Plug the power supply unit into a grounded electrical outlet. The cleaner is now ready for operation.

ຄໍາແນະນໍາການດໍາເນີນງານ

ເລີ່ມຕົ້ນຮອບວຽນທໍາຄວາມສະອາດ

1. Ensure the cleaner is properly submerged and the cable is untangled.
2. Press the ON/OFF button on the power supply unit. The cleaner will begin its cleaning cycle.
3. The Dolphin S50 utilizes CleverClean technology for smart navigation, ensuring optimal coverage of the pool floor.

Figure 4: The Dolphin S50 uses CleverClean technology for efficient pool scanning and navigation.


Figure 5: The Dolphin S50 completes a full cleaning cycle in approximately 1.5 hours.

Ending a Cleaning Cycle / Retrieving the Cleaner

1. Once the cleaning cycle is complete (approximately 1.5 hours), the cleaner will automatically shut off.
2. To retrieve the cleaner, pull the floating cable gently until the cleaner reaches the surface.
3. Use the handle to lift the cleaner out of the water. Allow excess water to drain from the cleaner before placing it on the pool deck.

Figure 6: The Dolphin S50 features a "Pick-me-up" mode for easy retrieval from the pool.
4. ຕັດການເຊື່ອມຕໍ່ເຄື່ອງເຮັດຄວາມສະອາດຈາກຫນ່ວຍສະຫນອງພະລັງງານ.

ບໍາລຸງຮັກສາ

ການເຮັດຄວາມສະອາດກະຕ່າການກັ່ນຕອງ

ມັນແນະນໍາໃຫ້ເຮັດຄວາມສະອາດກະຕ່າການກັ່ນຕອງຫຼັງຈາກແຕ່ລະຮອບການເຮັດຄວາມສະອາດເພື່ອຮັກສາປະສິດທິພາບທີ່ດີທີ່ສຸດ.

1. Ensure the cleaner is disconnected from the power supply.
2. Open the filter compartment cover (top access).
3. ເອົາກະຕ່າການກັ່ນຕອງອອກ.
4. Open the latches on the filter basket and separate the filter panels.
5. Rinse the filter panels thoroughly with a garden hose until all debris is removed.
6. Reassemble the filter basket and place it back into the cleaner. Close the filter compartment cover securely.

Figure 7: The top-access filter system allows for easy removal and cleaning of the filter basket.

Cleaning the PVC Brushes

Periodically inspect the PVC brushes for any trapped debris or wear. Clean them as needed to ensure effective scrubbing.

Figure 8: The Dolphin S50 features active PVC scrubbers for thorough cleaning of pool surfaces.

ການເກັບຮັກສາ

When not in use, store the Dolphin S50 in a cool, dry place, away from direct sunlight and extreme temperatures. Ensure the cable is neatly coiled to prevent kinks or damage.

ການແກ້ໄຂບັນຫາ

ຂໍ້ມູນຈໍາເພາະ

Figure 9: The Dolphin S50 is designed for pools up to 8 meters in length.

Figure 10: The compact design of the Dolphin S50 makes it ideal for small pools.

ການຮັບປະກັນ & ສະຫນັບສະຫນູນ

The Dolphin S50 Robotic Pool Cleaner comes with a ຮັບປະກັນ 2 ປີຈໍາກັດ. ການຮັບປະກັນນີ້ກວມເອົາຂໍ້ບົກພ່ອງຂອງວັດສະດຸແລະການເຮັດວຽກພາຍໃຕ້ການນໍາໃຊ້ປົກກະຕິ.

For warranty claims, technical support, or service inquiries, please contact Maytronics Australia directly or refer to their official webເວັບໄຊສໍາລັບຂໍ້ມູນຕິດຕໍ່.

ແນະນຳໃຫ້ລົງທະບຽນຜະລິດຕະພັນຂອງທ່ານເມື່ອຊື້ເພື່ອອຳນວຍຄວາມສະດວກໃຫ້ແກ່ຄວາມຕ້ອງການດ້ານການສະໜັບສະໜູນໃນອະນາຄົດ.

Figure 11: For ease of transport and storage, an optional caddy is available.