Ameda MYA Joy Double Electric Breast Pump Instruction Manual

ແນະນຳ

The Ameda MYA Joy Double Electric Breast Pump is a portable, hospital-grade breast pump designed for efficient and comfortable milk expression. It features up to 250 mmHg suction strength and can be used for single or double pumping. The pump is equipped with a HygieniKit system, which includes an FDA-cleared protective barrier to help prevent contamination. This manual provides detailed instructions for the setup, operation, and maintenance of your Ameda MYA Joy breast pump.

ມີຫຍັງແດ່

• ຈັກສູບໄຟຟ້າສອງເທົ່າ
• ເຄື່ອງປັບໄຟຟ້າ AC
• Customer Fit Flanges (25mm, 28.5mm)
• Dual HygieniKit
• 2 Extra Valves & Diaphragms

The Ameda MYA Joy comes with all necessary components to begin pumping, including the pump motor, power adapter, two sets of flanges (25mm and 28.5mm), two HygieniKits, and extra valves and diaphragms for convenience.

ຕັ້ງຄ່າ

Before first use, sanitize all parts of the HygieniKit (except adapter cap, tubing, tubing adapter, and pump motor). Recommended method for cleaning is boiling for 20 minutes. Allow parts to fully dry before assembly.

1. Assemble the HygieniKit Milk Collection System: Hold the valve by the flat edge and compress lightly. Gently push the valve onto the ring on the bottom of the breast flange. Attach and tighten the bottle. Then insert the diaphragm into the top of the flange.
2. ເຊື່ອມຕໍ່ທໍ່: Attach the adapter caps by pressing them onto the top of the flange until you hear a pop. Connect the tubing into the pump motor.
3. Power the Pump: Connect the AC power adapter to the pump motor and a power outlet. Alternatively, insert four AA batteries into the battery compartment for portable use.

The HygieniKit features a viral barrier to protect breast milk and pump components from contamination. Inspect parts regularly and replace if worn or damaged to maintain optimal performance.

ຄໍາແນະນໍາການດໍາເນີນງານ

Ensure proper fit of the breast flange on your breast to create a seal. Press the power button to turn on the device. The pump will start in Stimulation Mode.

• ໂໝດກະຕຸ້ນ: This mode uses short, sharp suctions to initiate milk let-down. You can adjust the stimulation vacuum level between 1 and 6 using the '+' and '-' buttons to your preferred comfort level.
• ໂໝດສະແດງອອກ: Once your milk starts to flow, press the 'M' (Mode) button to switch into Expression Mode. This mode uses longer, drawn-out suctions for efficient milk expression. You can adjust the expression vacuum level between 1 and 12 using the '+' and '-' buttons to your preferred comfort level.

The pump automatically switches from Stimulation Mode to Expression Mode after two minutes. To stop expressing, press the power button. Remove the milk collection kit from your breast.

ບໍາລຸງຮັກສາ

After every use, clean all parts of the milk collection kit (except tubing and adapter cap) in warm, soapy water. Rinse thoroughly and allow to air dry completely before next use. Do not clean the tubing or adapter cap unless milk or condensation is present inside, in which case they should be replaced.

ການແກ້ໄຂບັນຫາ

• ດູດໜ້ອຍ: Ensure all parts of the HygieniKit are correctly assembled and sealed. Check that the tubing is securely connected to both the pump motor and the adapter caps. Replace worn or damaged valves or diaphragms. If using batteries, ensure they are fresh and correctly inserted.
• ຊີວິດຫມໍ້ໄຟ: The pump operates on 4 AA batteries, providing approximately 2 hours of runtime. For extended use, connect the pump to the AC power adapter.
• ລະດັບສຽງລົບກວນ: The Ameda MYA Joy is designed to be quiet, with a noise level of up to 45 dB. If you notice unusual or excessive noise, ensure all components are properly connected and inspect for any damage.

ຂໍ້ມູນຈໍາເພາະ

ການຮັບປະກັນແລະການສະຫນັບສະຫນູນ

For warranty information and product support, please refer to the documentation included with your Ameda MYA Joy breast pump or contact Ameda's dedicated Parent Care team. Ameda is committed to supporting you throughout your breastfeeding journey.